hey, very nice bow, sweet tiller. Do hae the exact dimensions for this bow i've wanted to make one just like this for a while, but theres no info online...
The bow was made from a 1x2x1/2 board that was four feet long . It's made from red oak that had very, very thick growth rings and was very dense. 1.5 inches wide at the widest scallop. The side with out the scallops does not taper at all. The scallops are about 1/4 of and inch high, so the areas without the scallops are slighlty less than 1 1/4 inch wide at the narrowest point. I left 6 " between scallops for the handle area, and the space between all of the other scallops is 4". The last scallop ended up about 6 inches from the tip, and I tapered from there to a 7/8 inch wide fishtail pin nock, like the ones on many native bows. As far as width goes the center 6 inches is about 1/2 an inch thick and it tapers fairly straightly from there to 3/8 of and inch tips. (Before tillering). The tips ended up about 1/4 inch thick and I'm not sure on the mass but It is very light. If you need anything cleared up, just ask and Ill try to get some better dimensions. Good Luck.
