« previous next »
Pages: [1]

Author Topic: Glueing Ipe  (Read 1556 times)

0 Members and 1 Guest are viewing this topic.

Offline swimbill

  • Member
  • Posts: 79
Glueing Ipe
« on: January 23, 2011, 05:57:42 pm »
Tried to glue a riser to an Ipe slat today, the riser had a curve in it.  I bent the ipe over the riser clamped every inch, let the glue dry and unclamped.  The slat came right off the riser.  I was using titebond 2.  I cleaned the wood with acetone prior to glueing.  Any suggestions.
swimbill
Logged

Offline sucra

  • Member
  • Posts: 20
Re: Glueing Ipe
« Reply #1 on: January 23, 2011, 06:24:37 pm »
not take acetone, only soap and plenty of scrubbing with brush

Acetone takes a lot of oil and resin to the surface

Epoxy for bonding to take


Rolf
Logged
Rolf  from Germany

Offline bryan irwin

  • Member
  • Posts: 671
Re: Glueing Ipe
« Reply #2 on: January 23, 2011, 07:23:36 pm »
I've glued risers on with tight bond i clean it with denatured alcahol you must have a good wood to wood fit and let it cure for at least 24 houres.
Logged
bryan irwin

Offline macbow

  • Member
  • Posts: 54
Re: Glueing Ipe
« Reply #3 on: January 23, 2011, 07:57:29 pm »
Ipe is tough, bending it around the riser might be difficult. I usually back with bamboo glue the backing and Ipe into a R/D then shape the riser to the handle area.
Ron
Logged
Ron Mackenberg   Warsaw, MO.

Offline stiknstring

  • Member
  • Posts: 376
Re: Glueing Ipe
« Reply #4 on: January 23, 2011, 08:51:44 pm »
If your joint is so loose that you to work to get it to mate up you are courting disaster.
Logged
Pages: [1]
« previous next »