« previous next »
Pages: 1 [2]

Author Topic: How Did They Make These?  (Read 3506 times)

0 Members and 1 Guest are viewing this topic.

Offline JackCrafty

  • Global Moderator
  • Member
  • Posts: 5,628
  • Sorry Officer, I was just gathering "materials".
Re: How Did They Make These?
« Reply #15 on: January 11, 2011, 11:12:20 am »
Jesse, if you figure it out let us know!!

They (the arrowheads) look to be on the thick side with a diamond shaped cross section just behind the tip?  I'm going to try to make this style of tip also.  ;D
Logged
Any critter tastes good with enough butter on it.

Patrick Blank
Midland, Texas
Youtube: JackCrafty, Allergic Hobbit, Patrick Blank

Where's Rock? Public Waterways, Road Cuts, Landscape Supply, Knap-Ins.
How to Cook It?  200° for 24hrs then 275° to 500° for 4hrs (depending on type), Cool for 12hr

Offline Bill Skinner

  • Member
  • Posts: 384
Re: How Did They Make These?
« Reply #16 on: January 11, 2011, 08:41:12 pm »
Some Decauter tips are done like that.  Check out the Art Gumbus site, he shows a Decauter with a tip like that.  Bill
Logged

Offline JackCrafty

  • Global Moderator
  • Member
  • Posts: 5,628
  • Sorry Officer, I was just gathering "materials".
Re: How Did They Make These?
« Reply #17 on: January 12, 2011, 11:18:43 am »
I dunno, the DECATUR points that I looked at just now have burins struck off the tip to create a "chisel" point, not a faceted or multi-sided point.

I tried to create the burinated point last night, and I got close, but nothing like the precise points you see in the picture above.  Need nuch more practice... ;D
Logged
Any critter tastes good with enough butter on it.

Patrick Blank
Midland, Texas
Youtube: JackCrafty, Allergic Hobbit, Patrick Blank

Where's Rock? Public Waterways, Road Cuts, Landscape Supply, Knap-Ins.
How to Cook It?  200° for 24hrs then 275° to 500° for 4hrs (depending on type), Cool for 12hr

Offline outback118

  • Member
  • Posts: 18
Re: How Did They Make These?
« Reply #18 on: January 15, 2011, 04:15:53 pm »

Hi all, this is my first post so don’t boo me too much.
 
It's hard to tell from the photo , are the sides of the tips flat or are they a bit concave ?

 If they are flat I say the preform was ground to make that nice strong penetrating point then pressure flaked to put the rest of the cutting edge on .

If they are concave then I think they were flake in someway. I’m no expert, far from it but im going to try to make some that look like them.



Logged
Pages: 1 [2]
« previous next »