special design for whistle points

[stiventiger]

for the 100% copper made for fitting 5/16" vaired shafts and weight 195 Grains each, glue-on type,you should need taper little of the point end of your arrow shafts,quite simple and easy glue on,just in few seconds to fit.
for the iron&steel alloy made for fitting 5/16" vaired shafts and weight 155 Grains each, glue-on type,uniform tube size: no need taper the point end of your arrow shafts,quite simple and easy glue on,just in few seconds to fit.
i change the whistle points head design to let each have the whistle,now in market some the whistle points can't have the whistle sounds.

[Aries]

i wonder if they have any trouble with clogging if being shot at assorted targets...  card board target.. foam..    ?

[oat]

It 's take down design so you can take the tip out and clean the holes.
I am wondering if the very tip part going to collapse upon impact on hard target like dead tree.

[stiventiger]

i wonder if they have any trouble with clogging if being shot at assorted targets...  card board target.. foam..    ?

no problem,we test them a lot of time,see my ebay store describation:http://myworld.ebay.com/stmmrr1968
regards
tiger

[stiventiger]

It 's take down design so you can take the tip out and clean the holes.
I am wondering if the very tip part going to collapse upon impact on hard target like dead tree.

no problem,the tips are very thicker and stronger enough no collapse even impact rock etc,we test them a lot of time,see my ebay store describation:http://myworld.ebay.com/stmmrr1968
regards
tiger