« previous next »
Pages: [1]

Author Topic: Bark removal  (Read 1470 times)

0 Members and 1 Guest are viewing this topic.

Offline paul craig

  • Member
  • Posts: 15
Bark removal
« on: September 23, 2010, 12:39:02 am »
I put away a Saskatoon stave about 8 months ago without removing the bark from the back. Any advice on getting it off now without damaging the underlying wood?
Logged

Offline George Tsoukalas

  • Member
  • Posts: 9,425
    • Traditional and Primitive Archers
Re: Bark removal
« Reply #1 on: September 23, 2010, 09:56:27 am »
I carefully drawknife the bark off. I get what I can and scrape off the rest. There have been times when I've damaged the back. If I cut through a ring on the back then I have to remove that ring. Not easy with thin rings. Jawge
Logged
Set Happens!
If you ain't breakin' you ain't makin!

Offline Josh

  • Member
  • Posts: 3,367
  • Silence is golden but duct tape is silver.
Re: Bark removal
« Reply #2 on: September 23, 2010, 10:50:47 am »
I just debarked a Black Walnut stave Sunday night and the bark was stuck on it pretty bad.  I started with my drawknife and it wasn't working that good so I switched to my fillet knife.  For some reason it worked better than my draw knife did.  As I got closer to my back ring I switched to 60 grit sandpaper to get through the cambium layer.  And definitely be careful about going through a ring like Jawge said.  Good luck! :)
Logged
“The trouble with quotes on the Internet is you never know if they are genuine.” —Abraham Lincoln

Offline paul craig

  • Member
  • Posts: 15
Re: Bark removal
« Reply #3 on: September 23, 2010, 11:05:16 pm »
Thank you for your suggestions, Jawge and Josh!
Logged
Pages: [1]
« previous next »