« previous next »
Pages: 1 [2]

Author Topic: Arrow shafts  (Read 10994 times)

0 Members and 1 Guest are viewing this topic.

Offline markinengland

  • Member
  • Posts: 698
Re: Arrow shafts
« Reply #15 on: February 27, 2010, 02:49:27 pm »
I have cut wood on a saw to square, cut the corners off, then pulled it through a hole in a steel sheet (with sharp edges) using a drill. By gradually reducing the size of the hole a smooth shaft can be made. Not sure how it would work with a soft wood though.
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Arrow shafts
« Reply #16 on: February 27, 2010, 03:00:24 pm »
These are my shaft making tools. The thumb plane costs less that $10 at ACE hardware. The board was free from my basement.  Place 3/8" square stock in the groove in the board. With the plane remove the 4 corners, then the 8 corners then the 16 corners. Now sand it smooth and make an arrow from it.
  The other tools are for making arrows from the shafts.



Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC
Pages: 1 [2]
« previous next »