« previous next »
Pages: [1]

Author Topic: making wood laminates  (Read 1492 times)

0 Members and 1 Guest are viewing this topic.

Offline Eric Garza

  • Member
  • Posts: 589
making wood laminates
« on: January 26, 2010, 09:25:19 am »
I'm poised to begin learning to make laminate bows, and would like to cut my own laminates.  What sort of tools do people use to rip a 2 x 2 board (for instance) into full-length laminates?
Logged

Grunt

  • Guest
Re: making wood laminates
« Reply #1 on: January 26, 2010, 09:34:38 am »
I use a bandsaw and then a 40 grit belt on my 2x48 sander to finish the tapers.
Logged

Offline Justin Snyder

  • Administrator
  • Member
  • Posts: 13,794
Re: making wood laminates
« Reply #2 on: January 26, 2010, 10:55:22 am »
For me the ideal setup would be a bandsaw and a thickness sander. Any saw and a sanding board would work.
Logged
Everything happens for a reason, sometimes the reason is you made a bad decision.


SW Utah

Offline Josh

  • Member
  • Posts: 3,367
  • Silence is golden but duct tape is silver.
Re: making wood laminates
« Reply #3 on: January 26, 2010, 11:48:53 am »
I use a table saw to rip my boards to close to thickness/width, a bandsaw to cut the front view profile, and my belt sander to get my tapers right for glue-up.  I could probably do it with less tools but that's what i use... ;D  -josh
Logged
“The trouble with quotes on the Internet is you never know if they are genuine.” —Abraham Lincoln
Pages: [1]
« previous next »