Go down another ring or back?

[bigcountry]

I have been working on a stave for a long time.  After taking off litterly 10 rings, I finally got to one that is thick enough but for my handle I can't really got down another ring.

Do you think this pin will be a problem?  I was careful as I can be with it, but with a scraper, I scraped over it, and here is what is left.  The one on the left isn't that bad.  I don't think I will gain much going down another ring.   Its right after the fades.  I was thinking of sinewing.  Great looking stave.  Only pins on it.

[Hrothgar]

Those small pin knots shouldn't be a problem. They are near the handle, and with the larger one, there is still a little wood left between it and the edge of your bow. I would probably go ahead and back it with linen or sinew simply because I always back my bows. Ideally, if you had seen those knots earlier it would have been a good idea to have left a couple growth rings over the knots.
It really shouldn't be a problem. My first osage bow I literally de-crowned a big knot 2/3 of the way down the limb. After learning that was a no-no with osage, and not wanting to remove another 2 or 3 rings, I glued 2 linen patches over it, then put linen over the entire back. No problems at all, and it shoots bullets. Good luck

[bearbowman]

I'm not much of a bowyer yet but I would think it would be ok.
I say this because the knots are towards the center and they are located in the non working part of the limb.
I am sure someone with more experience will give their opinion soon.

[GregB]

You shouldn't have a problem with those, and as Bob said...they look like they're in the fades anyway.

[venisonburger]

Yep, what everyone else said, no problem
VB

[bigcountry]

Thanks guys, just a little FYI, thats not a crack, but a centerline I made with a fine pencil, I decided not to follwo.

[Eric Krewson]

Those are really minor pins. You could have them anywhere on the limb and they wouldn't be a problem. Pins are never a problem for me on osage. Mid limb or on the edge of a limb, I have never had one fail.