« previous next »
Pages: [1]

Author Topic: Board Bow 1st  (Read 2621 times)

0 Members and 1 Guest are viewing this topic.

Offline brokenarrow45

  • Member
  • Posts: 13
Board Bow 1st
« on: February 23, 2009, 01:33:39 am »
I just finished a board bow and it took about 2" of set, I wasn't too impressed with the cast and was wondering if I could do anything at this point to increase it. It is 58"ntn for a 24" draw if that matters.
Logged

jstarcher

  • Guest
Re: Board Bow 1st
« Reply #1 on: February 23, 2009, 02:18:49 am »
You could do a few things to help it out hard to say whats best without a picture though.  These assume your tiller is dead on.

1. Flip the tips use boil, steam, or dry heat reflex into them.
2. sinew it
3. maybe you tips are two wide shave em down a bit
4. chop an inch off each end
5. lastly leave it alone and make another even better! ;D
Logged

nickf

  • Guest
Re: Board Bow 1st
« Reply #2 on: February 23, 2009, 02:22:15 am »
I'd take a look at those tips and see if they're less than 1/2" wide, otherwise, scrape some off.
then make another one :)
Logged

Offline adb

  • Member
  • Posts: 5,339
Re: Board Bow 1st
« Reply #3 on: February 23, 2009, 09:36:30 am »
Can you provide any more detail on the bow? Pics would help also.
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Board Bow 1st
« Reply #4 on: February 23, 2009, 09:49:49 am »
At 58" it is probably too short for your first bow. Two inches of set isn't all that bad. There are things you can try but why not start another. Go a bit longer(68") and take your time with the tillering process.
   As adb said, pics are a big help for us.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline brokenarrow45

  • Member
  • Posts: 13
Re: Board Bow 1st
« Reply #5 on: February 23, 2009, 09:18:43 pm »
I think I will just leave it alone then. I have a vine maple stave that I am going to start working on though!
Logged
Pages: [1]
« previous next »