Author Topic: Apple Sucker Staves - How to store, how to make (eventually)  (Read 3045 times)

0 Members and 1 Guest are viewing this topic.

330bull

  • Guest
Apple Sucker Staves - How to store, how to make (eventually)
« on: February 15, 2009, 11:25:34 am »
Hello,

I just acquired three very nice apple sucker staves from an old apple tree.  They're ~1.75 yo 2.50" in diameter and rare at least 65" long. 

I cut the ends with a band saw and sealed with TBII.  I plan on storing in my garage until they are ready to become bows.

Questions:

1. I plan on NOT splitting in half (via bandsaw), due to fear of checking and twisting.  Does anyone agree or disagree?
2. I plan on making some nice bendy handle flatbows with a very similar profile to JD Duff's crabapple bow.  Does anyone have any other suggestions?

Thanks!  Joe

Ps.  The coolest part is that Wes has at least 4-6 more suckers on his tree, and his neighbor probably has 12 or more ready that I could make bows out of.  I though about taking them all but...haste makes waste.

Offline sailordad

  • Member
  • Posts: 5,045
Re: Apple Sucker Staves - How to store, how to make (eventually)
« Reply #1 on: February 15, 2009, 11:33:22 am »
    hi joe,

i have a limb from an apple tree that is about the same demensions.
i scraped all the bark and cambium layer off of he wood,sealed the ends.
i then analyzed the limb and decided which was to be the back and the belly.
then took my draw knife to the belly side and took off about 1/4 to 1/2" of wood.
lightly sealed the back and sides with wood glue and stuck it in the corner.
its been there for about 9 months now.i am hoping by next fall to make my wife
a new target bow from it.

and i would not try and split them with a band saw.you could end up wrecking them.
if you split them you might not have enough wood on either,especially the smaller one,to make a decent bow.
not to mention you might violate the grain severly.
jmho ;D

                                                                      peace,
                                                                           tim
i always wanted a harley,untill it became the "thing to ride"
i ride because i love to,not to be part of the crowd

Offline El Destructo

  • Member
  • Posts: 8,078
  • Longhaired Crippled Hippie Biker And Proud Of It!!
    • Desert Sportz Primitive Archery
Re: Apple Sucker Staves - How to store, how to make (eventually)
« Reply #2 on: February 15, 2009, 11:35:55 am »
Scrape the Bark off while it is still easy to do....and either reduce it like Tim has mentioned...or just seal the whole limb with a Sealer like Glue or urethane...and let it dry slowly to avoid splitting
As a species we're fundamentally insane. Put more than two of us in a room, we pick sides and start dreaming up ways to kill one another.Why do you think we invented politics and religion.
Think HEALTHCARE Is Expensive Now,Wait Till It's FREE
Do Or Do Not,There Is No TRY
2024...We Will Overcome

Offline Gordon

  • Member
  • Posts: 3,299
Re: Apple Sucker Staves - How to store, how to make (eventually)
« Reply #3 on: February 15, 2009, 12:26:21 pm »
Joe,

Split and debark the staves, rough out your bows and then let dry.
Gordon